(32Pcs) Propellers for DJI Mini 4K/Mini 2/Mini 2 SE/Mini SE,Drone Propellers Replacement Parts Orange Props for DJI Mavic Mini/Mavic Mini 2,Low Noise Quick Release Blades for DJI Mini 4K Accessories

Great deal
These replacement props work great. They cut the noise level slightly. The stability is equal to the OEM props. Very pleased with this purchase.

Very cheap set of extra propellers for the money
These worked good. Although when you tighten the propellers into the drone they seemed to have a little slack that wouldn’t screw in all the way . But I suppose that’s the way they were designed. There was a slight 1mm gap still present after you screwed the screws on tightly. I didn’t notice any big difference when flying with these propellers . They flew great. But was a little skeptical at first about the 1mm Freeplay slack it had after tightening the screws tightly. But glad I bought these , they work good , just gotta over look the little slack gap they had after installing them.

Will be buying again
Product showed up in a very timely manner… Seems to be in great condition but won’t know until I have to actually use them… but all good so far…

Excellent for the Money, but Use Caution – UPDATED
These are lighter than DJI props, ~555mg vs ~625mg, though flight characteristics remain the same. The included trunnion screws worked well, no issue with threading. After any prop replacement I recommend a shakedown flight in sport mode at low altitude to ensure everything has been assembled correctly and there are no defects in the blades. Reading these reviews, it looks as though a few people have cross threaded these. The screws should thread in at least 3 turns with very little resistance. Use some blue threadlocker to prevent them from backing out, and retighten before every session. If you do find a screw that has backed out some, make sure it hasn’t bent as well.I have logged about 12 hours of flight time on these and they are holding up well. They’ve seen some tall grass, tree branches and a couple run-ins with the walls inside my house and I’ve yet to replace one due to an inflight incident.*****UPDATE*****Ok, I did find a flaw. These blades are not sorted by weight like the DJI blades are, and can vary by as much as 30mg. The DJI sets are consistently matched to +-1mg. I started getting some wobble (jello effect) in my video after replacing one of the propsets. Note that they weren’t replaced due to wear, but I hastily yeeted the controller onto the drone when getting into my car, bending a blade. Replacing them again didn’t correct the issue so I weighed the blades. Sure enough there was a 21mg difference between the two. So I ended up taking all of the blades out of the bags and sorting them by weight. Most weighed 555 +-5mg but each box had a couple outliers. Lowest was 550 and highest was 580mg. The heaviest ones were lightly sanded evenly around the edge of the blade until i had an even number of matched sets. These are still a decent deal if you fly in rough situations and replace a lot of blades, but if you don’t already have a milligram-resolution scale they might be more hassle than they’re worth.